12-2-28-snyatie-i-ustanovka-kryshki-verkhnego-lyuka.html
12.2.28. Removal and installation of a cover of the top hatch
Details of installation of a cover of the top hatch (1 of 2)
Details of installation of a cover of the top hatch (2 of 2)
Removal
Design of an aligning core of the top hatch
Installation
|
- Grease with special paste (001 981 14 51) the left and right sliding captures.
- At the top fill a cover (4) in a hatch aperture.
- Screw, but yet do not tighten, fixing nuts (2) at the left and on the right.
- Press out a cover (4) by means of special nippers (shooter).
- Tighten nuts (2) and remove nippers (shooter).
- Completely open the hatch.
- With special paste (001 981 14 51) grease directing runners (1) and tighten them on regular, without tightening while finally fixing screws (5).
- Take the left and right aligning cores (3) and adjust the provision of a cover in an aperture.
|
It is better to charge performance of adjustment of a cover to specialists of car-care center. |
- Finally tighten fixing screws (5) and establish into place an internal upholstery of a cover (see. Section Removal and installation of the panel of an upholstery of a cover of the top hatch).
- Establish a rear-view mirror (see. A part the salon Equipment) also check serviceability of functioning of a drive of the top hatch.
|
|
|
|