Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
9.1. A full drive - the general information
9.2. Transfer case
9.3. Bridges
9.3.1. General information
9.3.2. Check and adjustment oil level / replacement in assemblies of bridges
9.3.3. Check of stuffing by greasing of sharnirny casings of rotary assemblies of the forward bridge
9.3.4. Adjustment of wheel bearings of a forward axis
9.3.5. Check of concentricity of landing of connecting flanges of leading gear wheels of the main transfers
9.3.6. Replacement of epiploons of leading gear wheels of the main transfers
9.3.7. Removal and installation of leading gear wheels of the main transfers
9.3.8. Removal, installation and adjustment of executive cylinders and components of the mechanism of a drive of blocking of interwheel differentials
9.3.9. Dismantling and assembly of the executive cylinder of a drive of blocking of differential
9.3.10. Removal and installation of naves of forward wheels
9.3.11. Dismantling and assembly of naves of forward wheels
9.3.12. Removal and installation of power shafts of the forward bridge
9.3.13. Adjustment of bearings of rotary knots
9.3.14. Dismantling and assembly of a sharnirny casing of the forward bridge
9.3.15. Dismantling and assembly of a power shaft
9.3.16. Removal and installation of semi-axes
9.3.17. Dismantling and semi-axis assembly
9.3.18. Removal and installation of assemblies of interwheel differentials with conducted gear wheels of the main transfers
9.3.19. Dismantling and assembly of interwheel differentials
9.3.20. Check of correctness of gearing of gear wheels of the main transfer
9.3.21. Removal and installation of assemblies of the forward and back bridge
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


9-3-15-razborka-i-sborka-privodnogo-vala.html

9.3.15. Dismantling and assembly of a power shaft

Design of a power shaft

1 — Collars
2 — the Boot
3 — the Spring washer

4 — the Hinge
5 — the Plug

 PERFORMANCE ORDER

  1. Remove a power shaft (see. Section Removal and installation of power shafts of the forward bridge).
  2. Remove both fixing collars (1) and shift back a rubber boot (2).
  3. Unclench a spring washer (3) and by means of a hammer with soft brisk bring down from a shaft pin a sharnirny hub (4).
  4. By means of a suitable press dismantle the plug (5).
  5. Carefully wipe the removed components, defective knots replace.
  6. Installation is made upside-down, - the plug (5) before landing to a shaft should be warmed up to temperature of 160 ÷ 180 °C. Do not forget to fill sharnirny knot durable greasing (000 989 63 51).

«previous page
9.3.14. Dismantling and assembly of a sharnirny casing of the forward bridge		 following page»
9.3.16. Removal and installation of semi-axes