Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
3.1. Specifications
3.2. Active system of the prevention of term of approach planned THAT (ASSYST)
3.3. Schedule of routine maintenance
3.4. General information on settings
3.5. Check of levels of liquids, control of leaks
3.6. Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
3.7. Replacement of impellent oil and oil filter
3.8. Check of brake system
3.9. Power supply system check, replacement of the fuel filter
3.10. Check of a condition and replacement of hoses of an impellent compartment, localization of leaks
3.11. Check of a condition of multicostal belts of a drive of auxiliary units
3.12. Check of functioning of system of cooling and frost resistance of cooling liquid, liquid replacement
3.13. Check of a condition of system of production of the fulfilled gases
3.14. ATF and AT filter replacement
3.15. Visual check of tightness of automatic transmission
3.16. Check of a condition of components of a suspension bracket and steering
3.17. Check of a condition of boots of power shafts
3.18. Check of central air of air
3.19. Greasing of limiters of doors and cylinders of locks
3.20. Visual control of seat belts and modules of safety cushions
3.21. Check of operability of headlights and horn
3.22. Check of a condition and replacement of brushes of screen wipers
3.23. Check of a condition of the battery, care of it and charging
3.24. Replacement of the salonny filter
3.25. Replacement of liquid of a drive of blocking of differential
3.26. Replacement of brake liquid
3.27. Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
3.28. Replacement of candles of an incandescence (diesel models)
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


3-20-vizualnyjj-kontrol-remnejj-bezopasnosti-i-modulejj-podushek-bezopasnosti.html

3.20. Visual control of seat belts and modules of safety cushions

 PERFORMANCE ORDER

  1. Completely extend a seat belt and check a tape on existence of the damaged threads.
  1. Damages can be a consequence, for example, jammings of a belt or influence of a burning cigaret. In this case it is necessary to replace a belt.
  2. In the presence of retyrannies without signs of damage of threads to replace a belt it is not necessary.
  3. The belt having a heavy course, it is necessary to check on twisting. If necessary it is necessary to remove facing on the central rack.
  4. If the machine gun of taking-up does not work, a belt it is necessary to replace (work HUNDRED).
  5. The tape of a belt can be cleared only soap and water. At all it is not necessary to apply for this purpose solvents or chemical cleaners.
  6. Check installation sites of safety cushions on existence of damages.
  7. Surface of a steering wheel and panels under which knots of inflatable safety cushions are located, clean the dry or moistened water a rag.

It is not allowed to paste over or fit any material a steering wheel and a surface of the forward panel on the right!


«previous page
3.19. Greasing of limiters of doors and cylinders of locks		 following page»
3.21. Check of operability of headlights and horn