Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
3.1. Specifications
3.2. Active system of the prevention of term of approach planned THAT (ASSYST)
3.3. Schedule of routine maintenance
3.4. General information on settings
3.5. Check of levels of liquids, control of leaks
3.6. Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
3.7. Replacement of impellent oil and oil filter
3.8. Check of brake system
3.9. Power supply system check, replacement of the fuel filter
3.10. Check of a condition and replacement of hoses of an impellent compartment, localization of leaks
3.11. Check of a condition of multicostal belts of a drive of auxiliary units
3.12. Check of functioning of system of cooling and frost resistance of cooling liquid, liquid replacement
3.13. Check of a condition of system of production of the fulfilled gases
3.14. ATF and AT filter replacement
3.15. Visual check of tightness of automatic transmission
3.16. Check of a condition of components of a suspension bracket and steering
3.17. Check of a condition of boots of power shafts
3.18. Check of central air of air
3.19. Greasing of limiters of doors and cylinders of locks
3.20. Visual control of seat belts and modules of safety cushions
3.21. Check of operability of headlights and horn
3.22. Check of a condition and replacement of brushes of screen wipers
3.23. Check of a condition of the battery, care of it and charging
3.24. Replacement of the salonny filter
3.25. Replacement of liquid of a drive of blocking of differential
3.26. Replacement of brake liquid
3.27. Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
3.28. Replacement of candles of an incandescence (diesel models)
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


3-15-vizualnaya-proverka-germetichnosti-avtomaticheskojj-transmissii.html

3.15. Visual check of tightness of automatic transmission

In AT it is not required to change oil during all term of operation.

The following belongs to number of the most probable places of development of leakages of ATF:

  • Plane of a joint of the block of cylinders and AT (back epiploon of a cranked shaft);
  • Place of connection of a power shaft to a transmission;
  • Drain stopper;
  • Jellied stopper.

 PERFORMANCE ORDER

  1. Clear AT case.
  2. Possible places of leaks sprinkle with a thin layer of chalk or talc.
  3. Make a trial trip on distance about 30 kilometers.
  4. Lift the car on the lift or over a viewing hole and by smudges of oil determine a place of leakage of oil.
  5. Eliminate leak and fill in oil in a transmission.

previous page
3.14. ATF and AT filter replacement		 following page
3.16. Check of a condition of components of a suspension bracket and steering