Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
11.1. Specifications
11.2. Forward suspension bracket
11.3. Back suspension bracket
11.4. Steering
11.4.1. General information
11.4.2. Check of a pressure of the steering pump
11.4.3. Check and adjustment of the hydraulic limiter
11.4.4. Adjustment of a steering shaft
11.4.5. Assessment of a condition of components of a steering drive
11.4.6. Removal and installation of a steering wheel
11.4.7. Removal and installation of a contact cable drum of a steering wheel
11.4.8. Removal and installation of the sensor of an angle of rotation of a steering wheel
11.4.9. Removal and installation of the mechanism of an electronic blokirator of a steering column
11.4.10. Removal and installation of a steering column with the adjustment electric drive
11.4.11. Removal and installation of the steering pump
11.4.12. Removal and installation of the line of cooling of GUR liquid
11.4.13. Removal and installation of the steering mechanism
11.4.14. Design of the steering mechanism
11.5. Suspension bracket geometry
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







11-4-5-ocenka-sostoyaniya-komponentov-rulevogo-privoda.html

11.4.5. Assessment of a condition of components of a steering drive

The Kardanny hinge (shooter) of a steering shaft should not have appreciable axial and radial люфтов

Visually examine everything steering tips

1 — the Tip of steering draft
2 — the Rotary lever / сошка

Size of a free wheeling (and) steering wheel should not fall outside the limits an admissible range

Estimate a condition of rubber boots (3) all of sharnirny knots of a steering drive

Assessment of a condition of a spherical finger of a tip of steering draft

4 — Sharovy a finger
5 — Adaptations for a boot otzhimaniye


 PERFORMANCE ORDER

  1. To Poddomkratta the car also establish it on props.
  2. Having hooked a screw-driver, manually make sure of absence axial люфта the kardanny hinge of a steering shaft (shooter). Having asked the assistant повращать a steering wheel to the right-to the left, check the hinge on existence radial люфта which also should not have a place.
  3. Estimate a condition of tips of steering drafts (1) in rotary levers / сошке the steering mechanism (2).
  4. Estimate size люфта (and) a steering wheel.
  5. Having carefully wiped, estimate a condition of rubber boots (3) sharnirny joints of components of a steering drive. In case of identification of cracks, traces of development of leaks and the other defects, the corresponding hinges should be replaced assembled, - simply replacement of a boot is assumed only at absolute confidence that in the hinge dirt could not get.
  6. The assessment of a condition of spherical fingers (4) steering tips can be made by a way of an otzhimaniye of boots by means of the special adaptation (5).


«previous page
11.4.4. Adjustment of a steering shaft
following page»
11.4.6. Removal and installation of a steering wheel