Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
10.1. Specifications
10.2. Check of brake system on leaks
10.3. Check of serviceability of functioning of the vacuum amplifier of brakes
10.4. Removal and installation of the tank of brake liquid and main brake cylinder (GTTs)
10.5. Removal and installation of the vacuum amplifier of brakes and sensor of a course of a diaphragm of BAS
10.6. Removal and installation of the vacuum pump (diesel engines)
10.7. Removal and installation of modules of management of ABS/EBV/ESP
10.8. Removal and ABS/4-ETS hydromodulator installation
10.9. Removal and installation of wheel ABS sensors
10.10. Removal and installation of rotors of wheel ABS sensors
10.11. Removal and installation of a pedal of a foot brake
10.12. Removal and installation of the lever of raising of the parking brake with a bearing bracket
10.13. Replacement of brake hoses
10.14. Check of a condition and replacement of brake shoes
10.15. Replacement of boots of the parking brake
10.16. Removal and installation of supports of brake mechanisms
10.17. Repair of a support of the fixed type
10.18. Check, removal and installation of brake disks
10.19. Removal and installation of components of a hummock drive of the parking brake
10.20. Adjustment of a drive of the parking brake
10.21. Pumping of brake system
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 




32 week ultrasound


10-19-snyatie-i-ustanovka-komponentov-trosovogo-privoda-stoyanochnogo-tormoza.html

10.19. Removal and installation of components of a hummock drive of the parking brake

Design of a hummock drive of the parking brake (1 of 2)

1 — the Bearing plate
2 — Driving cables
3 — the Rubber plug through passage
4 — the Arm

5 — the Lever of raising of the parking brake
38 — Adjusting nuts
and — Clamps

Design of a hummock drive of the parking brake (2 of 2)

11 — Clamps


 PERFORMANCE ORDER

  1. Uncover the lever of raising of the parking brake (5).
  2. Remove the central console and the left lateral panel of its furnish (see. Head Body).
  3. Unscrew adjusting nuts (38).
  4. Remove boots of the parking brake (see. Section Replacement of boots of the parking brake).
  5. Release fixture of fixing of a driving cable (2) to a bearing plate (1).
  6. Release clamps (and) fastenings of cables (2) to the car bottom.
  7. Liberate cables (2) of the plug (3) through passage in the bottom.
  8. liberate cables (2) of a basic arm (4).
  9. Carefully wipe all components and visually estimate their condition. In case of need make replacement.
  10. Installation is made upside-down, - pay attention to a difference in length of cables. For the purpose of simplification of a transmission of cables (2) in openings in the plug (3) through passage grease them with soap solution. A carving part of fixture of clamps of fastening of cables to the bottom grease with anticorrosive structure.
  11. In summary adjust a drive of the parking brake (see. Section Adjustment of a drive of the parking brake).


«previous page
10.18. Check, removal and installation of brake disks
following page»
10.20. Adjustment of a drive of the parking brake