Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
10.1. Specifications
10.2. Check of brake system on leaks
10.3. Check of serviceability of functioning of the vacuum amplifier of brakes
10.4. Removal and installation of the tank of brake liquid and main brake cylinder (GTTs)
10.5. Removal and installation of the vacuum amplifier of brakes and sensor of a course of a diaphragm of BAS
10.6. Removal and installation of the vacuum pump (diesel engines)
10.7. Removal and installation of modules of management of ABS/EBV/ESP
10.8. Removal and ABS/4-ETS hydromodulator installation
10.9. Removal and installation of wheel ABS sensors
10.10. Removal and installation of rotors of wheel ABS sensors
10.11. Removal and installation of a pedal of a foot brake
10.12. Removal and installation of the lever of raising of the parking brake with a bearing bracket
10.13. Replacement of brake hoses
10.14. Check of a condition and replacement of brake shoes
10.15. Replacement of boots of the parking brake
10.16. Removal and installation of supports of brake mechanisms
10.17. Repair of a support of the fixed type
10.18. Check, removal and installation of brake disks
10.19. Removal and installation of components of a hummock drive of the parking brake
10.20. Adjustment of a drive of the parking brake
10.21. Pumping of brake system
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 






цены на памятники из мрамора


10-11-snyatie-i-ustanovka-pedali-nozhnogo-tormoza.html

10.11. Removal and installation of a pedal of a foot brake

Details of installation of a pedal of a foot brake

1 — the Cover at the left under the dashboard
2 — the Socket
3 — the Pin of fastening of a pusher of GTTs
4 — Shplint
5 — the Spring

6 — the Lock ring
7 — Remote washers
8 — the Pedal
S9/1 — the Sensor switch of stoplights

 PERFORMANCE ORDER

  1. Uncover (1) at the left under the dashboard.
  2. Disunite the socket (2) electroconductings and remove the sensor switch of stoplights (S9/1).
  3. Remove шплинт (4) and take a fastening pin to the pedal lever (8) a pusher (3) GTTs.
  4. Disconnect a spring (5).
  5. Remove a lock ring (6).
  6. Remove a remote washer (7) and take the axial plug.
  7. Remove a pedal of a foot brake (8).
  8. Installation is made upside-down.

«previous page
10.10. Removal and installation of rotors of wheel ABS sensors		 following page»
10.12. Removal and installation of the lever of raising of the parking brake with a bearing bracket