Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
10.1. Specifications
10.2. Check of brake system on leaks
10.3. Check of serviceability of functioning of the vacuum amplifier of brakes
10.4. Removal and installation of the tank of brake liquid and main brake cylinder (GTTs)
10.5. Removal and installation of the vacuum amplifier of brakes and sensor of a course of a diaphragm of BAS
10.6. Removal and installation of the vacuum pump (diesel engines)
10.7. Removal and installation of modules of management of ABS/EBV/ESP
10.8. Removal and ABS/4-ETS hydromodulator installation
10.9. Removal and installation of wheel ABS sensors
10.10. Removal and installation of rotors of wheel ABS sensors
10.11. Removal and installation of a pedal of a foot brake
10.12. Removal and installation of the lever of raising of the parking brake with a bearing bracket
10.13. Replacement of brake hoses
10.14. Check of a condition and replacement of brake shoes
10.15. Replacement of boots of the parking brake
10.16. Removal and installation of supports of brake mechanisms
10.17. Repair of a support of the fixed type
10.18. Check, removal and installation of brake disks
10.19. Removal and installation of components of a hummock drive of the parking brake
10.20. Adjustment of a drive of the parking brake
10.21. Pumping of brake system
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







10-17-remont-supporta-fiksirovannogo-tipa.html

10.17. Repair of a support of the fixed type

Design of a support of the fixed type (brake mechanisms of forward wheels)

45 — Boots
47 — Pistons
50 — Cuffs
020 — Nippers for rotation of pistons

026 — Nippers
027 — Plates
040 — the Metal segment

 PERFORMANCE ORDER

  1. Remove a support (see. Section Removal and installation of supports of brake mechanisms).
  2. By means of nippers (026) and a suitable plate (027) unbend boots (45).
  3. Fill in a support a metal segment (040), then, having submitted the compressed air, wring out pistons (47) against the stop in cylinders.

As a segment the fragment of a brake disk can be used.

  1. By means of special nippers (020) take pistons from cylinders.
  2. Visually estimate a condition of working surfaces of pistons and cylinders. In case of need replace a support.
  3. Take from flutes in cylinders of a cuff (50).
  4. Installation is made upside-down, - before landing grease NEW cuffs (50) fresh brake liquid.


«previous page
10.16. Removal and installation of supports of brake mechanisms
following page»
10.18. Check, removal and installation of brake disks