Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
9.1. A full drive - the general information
9.2. Transfer case
9.2.1. Oil replacement in a transfer case
9.2.2. Removal and installation of the module of management of a transfer case
9.2.3. Removal and installation of a vacuum receiver of a control system by blocking of differentials
9.2.4. Removal and installation of the vacuum pump of a drive of blocking of differentials
9.2.5. Removal and installation of the servomotor of a transfer case
9.2.6. A detachment and connection of driveshafts on a transfer case
9.2.7. Removal and installation of a transfer case
9.2.8. Removal and installation of support of a suspension bracket of a transfer case
9.2.9. Design of a transfer case
9.2.10. Replacement of epiploons
9.2.11. Removal and installation of the executive cylinder of a drive of blocking of interaxal differential
9.2.12. Removal and installation of a forward cover
9.2.13. Removal and installation of a cover of the bearing of an intermediate flange
9.2.14. Dismantling and assembly of a cover of the bearing
9.2.15. Removal and installation of a cover of an intermediate flange
9.2.16. Removal and installation of an intermediate flange
9.2.17. Removal and installation of interaxal differential
9.2.18. Dismantling and assembly of interaxal differential
9.2.19. Removal and installation of entrance and intermediate shaft
9.2.20. Dismantling entrance (leading shaft)
9.2.21. Dismantling of an intermediate shaft
9.2.22. Removal and installation of components of the mechanism of inclusion of blocking of interaxal differential
9.2.23. Removal and installation of components of the mechanism of switching of modes of a transfer case
9.3. Bridges
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


9-2-2-snyatie-i-ustanovka-modulya-upravleniya-razdatochnojj-korobki.html

9.2.2. Removal and installation of the module of management of a transfer case

Details of installation of the module of management of a transfer case (N15/7)


 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate a service mode of system of an emergency call of TELE AID (see. Section Activation/deactivation of a service mode of system of an emergency call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. Remove the central console (see. Head Body).
  4. Remove the back module of activation and perception of a signal (SAM) / the assembly block of safety locks and the relay.
  5. Disconnect electroconducting, give four fixing nuts and remove the module of management of a transfer case (N15/7).
  6. Installation is made upside-down.
  7. In summary do not forget деактивировать a service mode of TELE AID system (at the corresponding complete set) and to make cleaning of memory of the processor of system of onboard self-diagnostics.

«previous page
9.2.1. Oil replacement in a transfer case		 following page»
9.2.3. Removal and installation of a vacuum receiver of a control system by blocking of differentials