Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
9.1. A full drive - the general information
9.2. Transfer case
9.2.1. Oil replacement in a transfer case
9.2.2. Removal and installation of the module of management of a transfer case
9.2.3. Removal and installation of a vacuum receiver of a control system by blocking of differentials
9.2.4. Removal and installation of the vacuum pump of a drive of blocking of differentials
9.2.5. Removal and installation of the servomotor of a transfer case
9.2.6. A detachment and connection of driveshafts on a transfer case
9.2.7. Removal and installation of a transfer case
9.2.8. Removal and installation of support of a suspension bracket of a transfer case
9.2.9. Design of a transfer case
9.2.10. Replacement of epiploons
9.2.11. Removal and installation of the executive cylinder of a drive of blocking of interaxal differential
9.2.12. Removal and installation of a forward cover
9.2.13. Removal and installation of a cover of the bearing of an intermediate flange
9.2.14. Dismantling and assembly of a cover of the bearing
9.2.15. Removal and installation of a cover of an intermediate flange
9.2.16. Removal and installation of an intermediate flange
9.2.17. Removal and installation of interaxal differential
9.2.18. Dismantling and assembly of interaxal differential
9.2.19. Removal and installation of entrance and intermediate shaft
9.2.20. Dismantling entrance (leading shaft)
9.2.21. Dismantling of an intermediate shaft
9.2.22. Removal and installation of components of the mechanism of inclusion of blocking of interaxal differential
9.2.23. Removal and installation of components of the mechanism of switching of modes of a transfer case
9.3. Bridges
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 









9-2-10-zamena-salnikov.html

9.2.10. Replacement of epiploons

On an example of an epiploon of a target flange of connection of the driveshaft of a drive of the forward bridge (replacement of epiploons of the remained two shaft is made in a similar manner)

Details of installation of epiploons of shaft of a transfer case

1 — the Connecting flange of connection of the driveshaft of a drive of the forward bridge
2 — the Connecting flange of connection of the driveshaft of a drive of a transfer case
3 — the Connecting flange of connection of the driveshaft of a drive of the back bridge of an axis

4 — Persistent washers
5 — Epiploons

 PERFORMANCE ORDER

  1. Disconnect from a transfer case driveshafts (see. The section Detachment and connection of driveshafts on a transfer case).
  2. Previously having marked its adjusting situation, remove a connecting flange (10), - in case of need use a stripper.
  3. By means of a suitable ex-tractor remove an epiploon (5).
  4. Installation is made upside-down. For landing of an epiploon use a suitable opravka (an epiploon previously grease with universal greasing of the Molykote type). Before installation of a flange fill in it bolts of fastening of the driveshaft.


«previous page
9.2.9. Design of a transfer case
following page»
9.2.11. Removal and installation of the executive cylinder of a drive of blocking of interaxal differential