Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
8.1. Specifications
8.2. Search of malfunctions - the general information
8.3. The general principles of functioning of a control system of the transmission, operating signals
8.4. Adjustment of a drive of switching of AT
8.5. Removal and installation of the electrohydraulic control unit by switchings
8.6. Removal and AT installation with the hydrotransformer
8.7. Removal and installation of the selector module (ESM)
8.8. Removal and installation of the sensor of target turns of AT
8.9. Removal and installation of a cooler of ATF
8.10. Washing of a cooler of ATF and oil pipelines
8.11. Removal and installation of the electronic module of management by transmission (TCM/ETC)
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


8-8-snyatie-i-ustanovka-datchika-vykhodnykh-oborotov-at.html

8.8. Removal and installation of the sensor of target turns of AT

Details of installation of the sensor of target turns of AT (1 of 2)

1 — the Lever of an otpuskaniye of a latch of the lock of a cowl
2 — the Cover
3 — the Socket

4 — the Sensor of target turns of AT (В49)
5 — the Bolt
6 — the plug of a cable Through passage

Details of installation of the sensor of target turns of AT (2 of 2)

7 — the Bolt of steering draft
8 — the Fixing collar

9 — the Nut

 PERFORMANCE ORDER

  1. Take a key from the ignition lock.
  2. Remove the lever (1) otpuskaniye of the lock of a cowl.
  3. Uncover (2) at the left under the dashboard, - the broken clamps replace.
  4. Previously having marked, disunite the socket (3).
  5. Remove a fixing bandage.
  6. Turn out a bolt (7) fastenings of steering draft.
  7. Having released a nut (9), weaken a fixing collar (8).
  8. Turn out a bolt (5) and remove the sensor of target turns of transmission (4), - in case of need prepare replaceable sealing laying. Remove an install label and transfer it on the new sensor.
  9. Accurately liberate sensor electroconducting from the plug (6) through passage in an impellent compartment.
  10. Installation is made upside-down.
  11. In summary make cleaning of memory of the processor of system of onboard self-diagnostics.

«previous page
8.7. Removal and installation of the selector module (ESM)		 following page»
8.9. Removal and installation of a cooler of ATF