Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
8.1. Specifications
8.2. Search of malfunctions - the general information
8.3. The general principles of functioning of a control system of the transmission, operating signals
8.4. Adjustment of a drive of switching of AT
8.5. Removal and installation of the electrohydraulic control unit by switchings
8.6. Removal and AT installation with the hydrotransformer
8.7. Removal and installation of the selector module (ESM)
8.8. Removal and installation of the sensor of target turns of AT
8.9. Removal and installation of a cooler of ATF
8.10. Washing of a cooler of ATF and oil pipelines
8.11. Removal and installation of the electronic module of management by transmission (TCM/ETC)
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







8-4-regulirovka-privoda-pereklyucheniya-at.html

8.4. Adjustment of a drive of switching of AT

Design of a drive of switching of AT

33 — the Executive lever
63 — Draught of switching
97 — the Intermediate lever

98 — a draft Head
99 — the Bolt
N15/5 — the Electronic selector module

 PERFORMANCE ORDER

  1. Tire out the car on the lift, lift and level strictly horizontally.
  2. Transfer the executive lever (33) to situation "D" and ask the assistant to hold him in this situation during the whole time of performance of procedure.
  3. Weaken a bolt (99).
  4. Connect a head of draft (98) to the intermediate lever (97) and fix it clamps.
  5. Fill draft (63) in a head, connect it to the lever (33) and fix clamps.
  6. Having pressed a head (98), tighten a bolt (99), - track, that draft (63) and a head (98) were not turned, and the lever (33) remained all the time in situation "D".
  7. Check serviceability of functioning of a drive.


«previous page
8.3. The general principles of functioning of a control system of the transmission, operating signals
following page»
8.5. Removal and installation of the electrohydraulic control unit by switchings