Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
8.1. Specifications
8.2. Search of malfunctions - the general information
8.3. The general principles of functioning of a control system of the transmission, operating signals
8.4. Adjustment of a drive of switching of AT
8.5. Removal and installation of the electrohydraulic control unit by switchings
8.6. Removal and AT installation with the hydrotransformer
8.7. Removal and installation of the selector module (ESM)
8.8. Removal and installation of the sensor of target turns of AT
8.9. Removal and installation of a cooler of ATF
8.10. Washing of a cooler of ATF and oil pipelines
8.11. Removal and installation of the electronic module of management by transmission (TCM/ETC)
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 









8-7-snyatie-i-ustanovka-selektornogo-modulya-esm.html

8.7. Removal and installation of the selector module (ESM)

Details of installation of the electronic selector module (ESM)

1 — the Cable of a drive of blocking of ignition
1b — the Lock uvula
1с — the Socket
2 — the Bolt
3 — the Intermediate lever
4 — Sealing laying

5 — the Socket
6 — the Safety lock
7 — the Nest
8 — Draught of switching
N15/5 — ESM

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate a service mode of system of an emergency call of TELE AID (see. Section Activation/deactivation of a service mode of system of an emergency call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. Disconnect draft of a drive of switching (8) from the intermediate lever (3) from below.
  4. Remove the central console
  5. Wring out a lock uvula (1b), turn the socket (1с) on 90 ° in the direction specified by an arrow and, having pulled, disconnect a cable of blocking of EIS (1) from the selector module (N15/5).
  6. Disunite the socket (5).
  7. Turn out bolts (2).
  8. Remove the selector module (N15/5), check a condition of its sealing laying (4), - in case of need make replacement.
  9. Installation is made upside-down.
  10. In summary disconnect a service mode of TELE AID system and make cleaning of memory of the module of onboard self-diagnostics (see. Head of System of electric equipment of the engine).


«previous page
8.6. Removal and AT installation with the hydrotransformer
following page»
8.8. Removal and installation of the sensor of target turns of AT