Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
5.1. System of cooling of the engine
5.1.1. Antifreeze - means of protection from freezing
5.1.2. Replacement of cooling liquid - general comments
5.1.3. Check of a cover of system of cooling, replacement of hoses of system of cooling
5.1.4. Thermostat check
5.1.5. Removal and thermostat installation
5.1.6. Removal and installation of a radiator of system of cooling
5.1.7. Removal and installation of a broad tank
5.1.8. Removal and installation of assembly of the fan of system of cooling
5.1.9. Removal and installation of the water pump
5.1.10. Removal and installation of a low-temperature cooler (М612)
5.1.11. Removal and installation of a heater of the block of the engine (at the corresponding complete set)
5.1.12. Removal and installation of an additional heater of STH (at the corresponding complete set)
5.1.13. Removal and installation of the circulating pump of an additional heater of STH (at the corresponding complete set)
5.2. Systems of ventilation, heating and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







5-1-10-snyatie-i-ustanovka-nizkotemperaturnogo-okhladitelya-m612.html

5.1.10. Removal and installation of a low-temperature cooler (М612)

Details of installation of a low-temperature cooler on diesel models with the M612 engine

1 — the Sleeve of a fence of air
2, 3 — Hoses of an okhladitelny path
4 — the line Perelivnaya of an okhladitelny path

5 — Auxiliary fans
6 — the Low-temperature cooler
7 — the Top cross-section beam of a front

 PERFORMANCE ORDER

  1. The low-temperature cooler is established on the diesel models equipped with the engine of a series 612.
  2. To Poddomkratta the car also establish it on props.
  3. Remove protection of a case.
  4. Empty cooling system (see. Head Current leaving and service).
  5. Remove a forward decorative lattice (see. Head Body).
  6. Remove a sleeve of a fence of air (1).
  7. Remove the top cross-section beam of a front (7) and take her aside, without removing the cowl lock.
  8. Disconnect hoses of an okhladitelny path (2 and 3), - in case of need prepare replaceable collars.
  9. Disconnect the perelivny line (4) of an okhladitelny path.
  10. Remove assembly of auxiliary fans (5) (see. Section Removal and installation of auxiliary ventilyatorny assembly).
  11. Having delayed forward, then having submitted up, remove assembly of a low-temperature cooler (6).
  12. Installation is made upside-down.
  13. In summary check cooling system on existence of signs of development of leaks and clear memory of the processor of system of onboard self-diagnostics (see. Head of System of electric equipment of the engine).


«previous page
5.1.9. Removal and installation of the water pump
following page»
5.1.11. Removal and installation of a heater of the block of the engine (at the corresponding complete set)