- At the corresponding complete set disconnect from a case of the back bridge draft of a regulator of brake pressure (see сопр. an illustration - models without EBV).
|
|
- Disconnect from a frame a diagonal bar of a suspension bracket.
|
|
- Disconnect the ventilating line.
|
|
- Prop up forward wheels protivootkatny boots, поддомкратьте the back bridge, then get props under arms of longitudinal levers of a suspension bracket.
|
|
- Release nuts and take bolts of the bottom support of shock-absorbers (see. Section Removal, check and installation of back shock-absorbers).
|
- Lower the bridge and remove screw springs of a suspension bracket, - try not to jam when lowering the bridge brake lines.
|
|
- In case of need remove rubber bufer.
|
|
- Installation is made upside-down, - track, that end faces of prutok of springs rested against special ledges of the bottom plates.
|
|
|
|
Replaceable springs should have the same color marking, as original. |
|