Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
11.1. Specifications
11.2. Forward suspension bracket
11.3. Back suspension bracket
11.3.1. General information
11.3.2. Removal and installation of assembly of the back bridge
11.3.3. Removal, check and installation of back shock-absorbers
11.3.4. Removal and installation of springs of a forward suspension bracket
11.3.5. Removal and installation of the back stabilizer of cross-section stability
11.3.6. Removal and installation of longitudinal levers of a suspension bracket
11.4. Steering
11.5. Suspension bracket geometry
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







11-3-3-snyatie-proverka-i-ustanovka-zadnikh-amortizatorov.html

11.3.3. Removal, check and installation of back shock-absorbers

Design of the top support of the shock-absorber

Location of the bottom support of the back shock-absorber


 PERFORMANCE ORDER

  1. Release a nut (1), then remove a plate (2) with the rubber plug (3) and liberate the shock-absorber from the top basic arm (4).
  2. Remove from the shock-absorber the holder (5 and 8), the rubber bearing (6) and the remote plug (7).
  3. Release a nut, take a bolt (shooter) and remove the shock-absorber from the bottom support.
  4. Estimate a condition of the rubber components, the failed elements replace.
  5. Examine the shock-absorber on existence of traces of leaks through cuffs of a working rod, in case of need prepare replaceable assemblies.
  6. Installation is made upside-down. Track, that the fixture was tightened with demanded effort.


«previous page
11.3.2. Removal and installation of assembly of the back bridge
following page»
11.3.4. Removal and installation of springs of a forward suspension bracket