Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
7.1. Ignition and engine management systems
7.1.1. Main data and security measures
7.1.2. Checks of a control system by ignition and injection
7.1.3. Search of malfunctions - the general information and preliminary checks
7.1.4. Check and adjustment of a corner of an advancing of ignition
7.1.5. Spark plugs
7.1.6. Removal and installation of coils of ignition, - petrol models
7.1.7. Removal and installation of the sensor of provision of a cranked shaft (CKP)
7.1.8. Removal and installation of the sensor of the Hall of a camshaft
7.1.9. Removal and installation of sensors of a detonation (KS), - petrol engines
7.2. System of preheat of the diesel engine
7.3. Diagnostics of systems of electronic control and diagnostic equipment
7.4. Charging and start systems
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 







7-1-7-snyatie-i-ustanovka-datchika-polozheniya-kolenchatogo-vala-ckp.html

7.1.7. Removal and installation of the sensor of provision of a cranked shaft (CKP)

Petrol models

Details of installation of the CKP sensor (L5) of petrol engines

 PERFORMANCE ORDER

  1. After replacement of the CKP sensor it is necessary to make a reinitsializatsiya of the module of management with use of the special diagnostic equipment, - it is most reasonable to charge performance of this procedure to specialists of car-care center.

Diesel models (М612)

Details of installation of the CKP sensor of the M612 engine

 PERFORMANCE ORDER

  1. Remove panels of furnish of a cover of a head of cylinders.
  2. Disunite the contact socket (1).
  3. Turn out a fixing bolt (2) and remove the CKP sensor (L5).
  4. Installation is made upside-down.


«previous page
7.1.6. Removal and installation of coils of ignition, - petrol models
following page»
7.1.8. Removal and installation of the sensor of the Hall of a camshaft