Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
7.1. Ignition and engine management systems
7.1.1. Main data and security measures
7.1.2. Checks of a control system by ignition and injection
7.1.3. Search of malfunctions - the general information and preliminary checks
7.1.4. Check and adjustment of a corner of an advancing of ignition
7.1.5. Spark plugs
7.1.6. Removal and installation of coils of ignition, - petrol models
7.1.7. Removal and installation of the sensor of provision of a cranked shaft (CKP)
7.1.8. Removal and installation of the sensor of the Hall of a camshaft
7.1.9. Removal and installation of sensors of a detonation (KS), - petrol engines
7.2. System of preheat of the diesel engine
7.3. Diagnostics of systems of electronic control and diagnostic equipment
7.4. Charging and start systems
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


7-1-6-snyatie-i-ustanovka-katushek-zazhiganiya-benzinovye-modeli.html

7.1.6. Removal and installation of coils of ignition, - petrol models

Before starting performance of procedure familiarize with the list of security measures stated in the Section the Main data and security measures!

Details of installation of coils of ignition on petrol engines

5/1 — the Tip of the candle socket
5/3 — the Bolt
T1/1 — the Coil of ignition of the cylinder No. 1
T1/2 — the Coil of ignition of the cylinder No. 2
T1/3 — the Coil of ignition of the cylinder No. 3
T1/4 — the Coil of ignition of the cylinder No. 4

T1/5 — the Coil of ignition of the cylinder No. 5
T1/6 — the Coil of ignition of the cylinder No. 6
T1/7 — the Coil of ignition of the cylinder No. 7
T1/8 — the Coil of ignition of the cylinder No. 8
Arrow — the Identification label of a tip

 PERFORMANCE ORDER

  1. Remove panels of furnish of a cover of a head cylinders/air purifier.
  2. Turn out a fixing bolt (5/3).
  3. Disconnect electroconducting from the corresponding spark plug (5/1).
  4. Disunite the contact socket of electroconducting and remove bobbin assembly (T1/x).
  5. Installation is made upside-down.

«previous page
7.1.5. Spark plugs		 following page»
7.1.7. Removal and installation of the sensor of provision of a cranked shaft (CKP)