Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
11.1. Specifications
11.2. Forward suspension bracket
11.3. Back suspension bracket
11.4. Steering
11.5. Suspension bracket geometry
11.5.1. Corners of installation of wheels of the car - the general information
11.5.2. Adjustment of convergence of forward wheels
11.5.3. Determination of the demanded size выбега
11.5.4. Check and adjustment of limiting angles of rotation of forward wheels
11.5.5. Check of size of wheel base
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


11-5-4-proverka-i-regulirovka-predelnykh-uglov-povorota-perednikh-koles.html

11.5.4. Check and adjustment of limiting angles of rotation of forward wheels

Check of size of a limiting angle of rotation of a wheel is made on the special platform equipped with rotary disks (3)

Adjustment of size of a limiting angle of rotation of a wheel

1 — the Lock screw
2 — the Lock-nut

Check is made on the special platform equipped with rotary disks.

Than the bigger size forward wheels are established on the car, the limiting size of their turn should be that less. Remember that the distance from edge of the tire of the wheel turned against the stop to the corresponding longitudinal lever of a forward suspension bracket should make about 2 see.

In case of need release a lock-nut (2) and rotation of the lock screw (1) carry out demanded adjustment. Upon termination of do not forget to tighten a lock-nut (2).

«previous page
11.5.3. Determination of the demanded size выбега		 following page»
11.5.5. Check of size of wheel base