Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
11.1. Specifications
11.2. Forward suspension bracket
11.3. Back suspension bracket
11.4. Steering
11.5. Suspension bracket geometry
11.5.1. Corners of installation of wheels of the car - the general information
11.5.2. Adjustment of convergence of forward wheels
11.5.3. Determination of the demanded size выбега
11.5.4. Check and adjustment of limiting angles of rotation of forward wheels
11.5.5. Check of size of wheel base
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 


11-5-2-regulirovka-skhodimosti-perednikh-koles.html

11.5.2. Adjustment of convergence of forward wheels

Check of geometrical parameters of a suspension bracket should be made at the special stand in the conditions of a car-care center workshop.

Check and adjustment of convergence of forward wheels

1 — the Label on a steering shaft
2 — the Label on a casing of the steering mechanism
3 — Cross-section steering draft

4 — Coupling collars
5 — Connecting draft
6 — Lock-nuts

 PERFORMANCE ORDER

  1. Make sure of performance of all necessary conditions (see. The section Corners of installation of wheels of the car - the general information).
  2. Make sure that the steering wheel and the steering mechanism are in the central situation, - the long label (1) on a steering shaft should be combined with a label (2) on a casing of the steering mechanism. In case of need adjust the provision of a steering wheel, having displaced it no more than on one tooth.
  3. Fix a steering wheel in the central situation and establish a blokirator, having in case of need enclosed under it protective laying.
  4. Release lock-nuts (6) on cross-section draft (3) and coupling collars (4) on connecting draft (5).
  5. Adjustment of size of convergence is made by rotation of the adjusting segment of connecting draft located between coupling collars (5) and, - in case of need, - a tip of cross-section draft (3) which should be liberated previously from a steering soshka by means of a suitable stripper.
  6. Having achieved demanded result, tighten lock-nuts (6) and collars (4).

«previous page
11.5.1. Corners of installation of wheels of the car - the general information		 following page»
11.5.3. Determination of the demanded size выбега