Mercedes-Benz G-class (W463) since 1999 of release
1. Introduction
2. Governing bodies and operation receptions
3. Current leaving and service
4. Engine
4.1. Check of kompressionny pressure, assessment of a condition of cylinders
4.2. Engine check by means of the vacuum gage
4.3. Replacement of a belt of a drive of auxiliary units and elements of the mechanism of its tension
4.4. Check of pressure of impellent oil
4.5. Calculation of a consumption of oil
4.6. Check and adjustment of base provision of camshafts
4.7. Verification of the base provision of a balancing shaft (only M112 engines and 628)
4.8. Check of a condition of a chain of a drive of GRM on the M628 engine
4.9. Check of correctness of installation of a corner of an advancing of ignition on petrol models
4.10. Removal and installation of the power unit
4.11. Removal and installation of support of a suspension bracket of the power unit
5. Systems of cooling, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Automatic transmission
9. Transmission line
10. Brake and auxiliary systems
11. Suspension bracket and steering
12. Body
13. Onboard electric equipment
14. Schemes of electric connections


 









4-9-proverka-pravilnosti-ustanovki-ugla-operezheniya-zazhiganiya-na-benzinovykh-modelyakh.html

4.9. Check of correctness of installation of a corner of an advancing of ignition on petrol models

Check of a corner of an advancing of ignition on petrol models


 PERFORMANCE ORDER

  1. The corresponding illustrative material is presented on an illustration Installation of base provision of camshafts of petrol M112/113 engines and than an illustration is higher, which all references meeting in the text concern.
  2. Remove covers of a head of cylinders (see an illustration of the Detail of installation of covers of heads of cylinders on petrol M112/113 engines (on example М112)).
  3. On the models equipped with the air pump отболтите the combined valve (the right head), - sealing laying of the valve is subject to replacement without fail.
  4. Check correctness of installation of a corner of an advancing of ignition (see. Specifications).
  5. Develop the engine in situation 40 ° after VMT of the piston of the first cylinder (see. Section Check and adjustment of base provision of camshafts).
  6. Check the base provision of camshafts (see. Section Check and adjustment of base provision of camshafts).
  7. On the models equipped with the M112 engine, check the base provision of a balancing shaft (see. Section Verification of the base provision of a balancing shaft (only M112 engines and 628)).
  8. Installation is made upside-down.


«previous page
4.8. Check of a condition of a chain of a drive of GRM on the M628 engine
following page»
4.10. Removal and installation of the power unit